C 1500 Yukon 2WD V8-5.3L VIN T (2002)
3. Install the brake caliper to the brake caliper mounting bracket.
4. Perform the following procedure before installing the caliper guide pin bolts.
4.1.
Remove all traces of the original adhesive patch.
4.2.
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
4.3.
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
5. Install the brake caliper mounting bolts.
Notice: Refer to Fastener Notice in Service Precautions.
6. Tighten the brake caliper guide pin bolts - rear 15 Series.
Tighten the to 42 Nm (31 ft. lbs.).
7. Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install 2 New copper brake hose gaskets.
8. Assemble the 2 New copper brake hose gaskets and the brake hose to caliper bolt to the brake hose.
9. Connect the brake hose at the caliper by installing the brake hose to caliper bolt.
Tighten the brake hose to caliper bolt to 40 Nm (30 ft. lbs.).
10. Bleed the hydraulic brake system.
11. Install the tire and wheel assembly.
12. Lower the vehicle.
13. Fill the master cylinder reservoir to the proper level with clean brake fluid.
