C 1500 Yukon 2WD V8-5.3L VIN T (2002)
Parking Brake Cable: Service and Repair
Park Brake Cable Mounting Bracket Replacement
Park Brake Cable Mounting Bracket Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Release the tension on the cables by loosening the nut at the equalizer.
4. Disconnect the rear cables from the equalizer.
5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
6. Remove the cable support bracket nuts.
7. Remove the cable support bracket.
Installation Procedure
1. Install the cable support bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cable support bracket nuts.
Tighten the support bracket nuts to 85 Nm (64 ft. lbs.).
3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
4. Connect the rear cables to the equalizer.
