C 1500 Yukon XL 2WD V8-5.3L VIN T (2001)
6. Clean and prepare all of the bare metal surfaces.
IMPORTANT: Prior to refinishing, refer to the publication GM 4901 M-D-2000 GM Approved Refinish Materials for recommended products. Do
not combine paint systems. Refer to paint manufacturer's recommendations.
7. Apply approved anti-corrosion primer.
8. Feed fish wire (1), GM P/N 15017229 or the equivalent, through the hinge, the hinge stud hole and out of the conduit hole in the pillar.
9. Install stud (2), GM P/N 15017230, supplied with the service hinge into the wire end. Pull the stud into position.
10. Hold the stud in position with the hinge and remove the fish wire.
11. Draw the stud (4) tight through the pillar. Use the nuts GM P/N 11516746 supplied.
12. Repeat steps 8-11 on the remaining stud locations.
13. Remove each service nut.
14. Apply a full-bodied caulk to the entire hinge mounting surface in order to ensure a proper seal.
NOTE: Refer to Fastener Notice in Service Precautions.
15. Install the hinge (2) to the pillar (3). Use the supplied nuts (1).
Tighten
Tighten the hinge nuts (4) to 25 N.m (18 lb ft).
16. Clean and prepare all of the surfaces a necessary for refinishing.
17. Apply the sealers.
18. Refinish the surfaces as necessary.
19. Install and align all of the related panels and the components.
Hinge Replacement - Front Door - Door Side
