C 1500 Yukon XL 2WD V8-5.3L VIN T (2001)
11. Fit the seat cover around the air bag cover.
12. Pull the seat belt down through the seat cushion and install the outboard seat belt anchor nut.
Tighten the nut to 53 N.m (39 lb ft).
13. Install the seat trim panel.
14. Install the head restraints.
15. Push on the seat cover. Ensure that the cover is retained by the velcro in the seat cushion.
16. Connect the J-strip at the bottom of the seat.
17. If equipped with side air bags, enable the air bag module. Refer to Enabling the SIR System in SIR.
Rear Seat Back Cushion Cover and Pad Replacement (Extended Cab w/ 4th Door)
Rear Seat Back Cushion Cover and Pad Replacement (Extended Cab w/ 4th Door)
Removal Procedure
1. Remove the armrest from the seat back.
2. Remove the head restraints (9) from the seat back.
3. Release the bottom edge of the seat back cover (2).
4. Release the hook and loop strips retaining the seat back cover to the seat back foam pad (1).
5. To ease removal, place a piece of cardboard between the seat back cover and the foam pad.
6. Working from side to side, carefully lift the seat back cover from the foam pad.
Installation Procedure
1. Working from side to side, carefully install the seat back cover over the foam pad.
