C 1500 Yukon XL 2WD V8-5.3L VIN T (2001)
2.2.
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
2.3.
Apply Threadlocker GM P/N 12345493 or Red LOCTITE TM #272 to the threads of the bolt.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the backing plate bolts.
^
Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
4. Install the park brake shoe.
5. Install the axle shaft.
6. Adjust the park brake shoe.
7. Install the rotor.
8. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
9. Install the rear park brake cable to the park brake actuator lever.
10. Tighten the nut to the intermediate cable at the equalizer.
^
Tighten the nut to 3.5 Nm (31 inch lbs.).
11. Install the tire and wheel assembly.
12. Remove the safety stands.
13. Lower vehicle.
14. Adjust park brake cable.
Brake Rotor Replacement - Rear (Dual Wheels)
Brake Rotor Replacement - Rear (Dual Wheels)
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the
midway point before proceeding.
4. Remove the hub and rotor assembly.
5. Mark the relationship of the hub to the rotor.
6. Place the hub and rotor assembly on a hydraulic press.
7. Press the wheel studs out of the, hub and rotor assembly.
Installation Procedure
1. Align the hub and the rotor (if applicable).
2. Press the wheel studs into the hub and rotor assembly.
3. Install the hub and rotor assembly.
4. Lower the vehicle.
5. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
6. Slowly release the brake pedal.
7. Wait 15 seconds, then repeat steps 5-6 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
8. Fill the master cylinder reservoir to the proper level with clean brake fluid.
Disc Brake Backing Plate Replacement Rear (25/35 Series)
Disc Brake Backing Plate Replacement Rear (2500 Series)
Removal Procedure
