C 1500 Yukon XL 2WD V8-8.1L VIN G (2001)
5. Remove the tool kit from the vehicle.
Installation Procedure
1. Install the tool kit and the retaining nut.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the jack and the bracket with the retaining nut.
Tighten the nuts to 9 N.m (80 lb in).
3. Install the nut retaining the tool stowage cover, if equipped.
Jack and Tool Stowage Replacement (Suburban/Yukon XL)
Jack and Tool Stowage Replacement (Suburban/Yukon XL)
Removal Procedure
1. Remove the storage tray located in left rear of vehicle.
2. Remove the wing nut retaining the tool kit bracket.
3. Turn the adjusting knob on jack assembly counter-clockwise.
4. Remove the jack.
Installation Procedure
