C 1500 Yukon XL 2WD V8-8.1L VIN G (2001)
5. Remove the engine shield bolts.
6. Remove the engine shield.
7. Remove the engine harness clips (2) from the lower oil cooler pipe.
8. Remove the oil cooler pipe clip bolt.
9. Perform the following steps on both the engine block quick connect fittings:
9.1.
Disengage the plastic caps from the quick connect fittings. Pull the caps back along the pipes.
9.2.
Hold one leg of the retaining clip.
9.3.
Using a small pick-type tool (or bent screwdriver) gently pry the other end of the retaining clip from the quick connect fitting.
9.4.
Rotate the retaining clip out of the quick connect fitting. Remove the retaining clip completely.
9.5.
Discard the OLD retaining clips.
10. Gently pull the oil cooler pipe fittings straight out from the engine block quick connect fittings.
11. Remove the engine oil cooler hose/pipe assembly from the vehicle.
Installation Procedure
