C 1500 Yukon XL 2WD V8-8.1L VIN G (2001)
Seat Belt Buckle: Service and Repair
Seat Belt Buckle and Latch Replacement - #2 Rear
REMOVAL PROCEDURE
1. Remove the door sill plate.
2. Remove the seatbelt anchor bolt cover.
3. Remove the floor anchor bolt.
4. Remove the third pillar trim panel.
5. Route the belt through trim panel.
6. Remove the lower guide.
7. Remove the bolt from the upper guide.
8. Remove the bolt from the retractor.
9. Remove the assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install the assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt to the retractor.
Tighten
Tighten the bolt to 55 N.m (41 lb ft).
3. Install the bolt to the upper guide.
Tighten
Tighten the bolt to 55 N.m (41 lb ft).
