C 2500 3/4 Ton Pickup 2WD V8-379 6.2L DSL VIN J FI (1984)
-OIL PUMP ASSEMBLY
16.
Install oil pump assembly and torque bolts to 90 N-m (66 ft.lbs.)
17.
Apply a 5 mm (3/16") bead of RTV sealer, GM P/N 22521437 or 1052915 (GE 1673 or equivalent on the top and bottom of the oil pan's new
rear neoprene seal and also to each end of seal where it contacts the cylinder block. Sealant must also be applied along the pan rail's entire
INNER edge and around all bolt holes.
18.
Install the oil pan while RTV is still wet to the touch and torque all bolts to 10 N-m (7 ft.lbs.)
except two rear bolts, which are 22 N-m (16 ft. lbs.)
19.
Let RTV set 30 minutes, which is sufficient skim-over time for the RTV, before retesting engine for leaks.
WARRANTY INFORMATION
When the rear main seal is replaced on 6.2L diesel engines under warranty, the new two-piece Viton seal (P/N 23500417) must be used. The Labor Time
Guide will be adjusted to reflect this change as follows:
Labor Operation:
J1100
Seal, Rear Main Bearing - R & R
or Repack is no longer valid and must not be used.
Labor Operation:
J1120
"Seal crankshaft rear main
replace", will pay "C, K" 2.8 hrs. "G" 4.0 hrs.
Add:
With strut rods "K" .2 hr.
