C 2500 3/4 Ton Pickup 2WD V8-379 6.2L DSL VIN J FI (1984)
3.
Remove the filter.
4.
Clean any dirt off the fuel port sealing surface of the filter adapter and the new filter.
5.
Install the new filter; snap into position with bail wires.
6.
Close the water drain valve and open the air bleed. Connect a 1/8" I.D. hose to the air bleed port and place the other end into a suitable container.
FIGURE 3 - Injection Pump
7.
Disconnect fuel injection pump shut off solenoid wire (Figure 3).
8.
Crank engine for 10 to 15 seconds and wait 1 minute for the starter motor to cool. Repeat until clear fuel is observed coming from the air bleed.
9.
Close the air bleed, reconnect the injection pump solenoid wire and replace fuel tank cap.
10.
Start engine and allow it to idle for 5 minutes.
11.
Check fuel filter for leaks.
Fuel Exhaustion, Engine Stops
