C 2500 3/4 Ton Pickup 2WD V8-379 6.2L DSL VIN J FI (1984)
FIGURE 3 - Injection Pump
3.
Disconnect the fuel return hose at the injection pump (Figure 3).
4.
With the fuel tank cap properly installed, apply a low pressure 20.6 - 34.4 kPa (3-5 psi) maximum air through the fuel return hose.
The fuel tank cap is designed to retain 20.6 - 34.4 kPa (3-5 psi) pressure, allowing water to be forced out of the tank via the filter
drain hose.
5.
Continue to drain until only clear fuel is observed - the complete contents of the tank may have to be drained.
6.
Close drain valve tightly. Reinstall the fuel return hose.
Fuel Filter Replacement
The fuel filter is easily removed and installed with the use of a screwdriver. To prevent fuel spillage -- drain fuel
from the filter by opening both the air bleed and water drain valve allowing fuel to drain out into an appropriate container.
To remove the filter:
1.
Remove fuel tank cap. This releases any pressure or vacuum in the tank.
2.
Disengage both bail wires with a screwdriver.
