C 2500 Suburban 2WD V8-350 5.7L (1994)
2.
Remove the retainer from the brake pedal pin and unsnap the stop lamp switch from the pushrod (Figure 1).
3.
Remove the wiring connector from the switch and discard the switch.
4,
With the switch removed, unsnap the side/locking cover on the wiring connector and remove the wires in cavities A & B. Re-index the wires as
follows:
-
Utilities end Suburbans
White wire in cavity A, and the orange wire in cavity B.
-
All other models
Yellow wire in cavity A, and the orange wire in cavity B.
5.
Repair the locking tab on the terminals and insert wires into the new cavities and snap closed the side/locking cover on the connector.
6.
ReInstall the wiring connector to the new stoplamp switch and snap the switch to the pushrod (Figure 1).
7.
Locate the switch on the brake pedal pin and install the retainer.
8.
Connect the negative battery cable.
9.
Install the GM Campaign Identification Label.
Campaign Identification Label
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campai9n number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label is to be located on the radiator core support in an area which will be visible when the vehicle is brought in by the
