C 2500 Suburban 2WD V8-350 5.7L (1994)
Thermostatic Air Cleaner: Service and Repair
Wax Pellet Installation
Remove or Disconnect:
-
Vehicle air cleaner assembly.
-
If application has a plastic heat tube elbow, use an 1/8" drill bit to drill out the two rivets that secure it to the heat tube and remove elbow. If
application does NOT have an elbow, skip this step.
-
Use an 1/8" drill bit to drill out the rivets that secure the wax pellet carrier assembly.
-
Remove the blow down spring.
-
Remove the wax pellet carrier assembly.
-
Examine spring clip on the hot air damper. Replace if necessary.
Install or Connect:
-
Install new blow down spring.
-
Reinstall plastic heat tube elbow in the correct orientation, using two pop rivets. If application does NOT have an elbow, skip this step.
-
Reinstall air cleaner assembly on vehicle.
-
Check thermostatic air cleaner to ensure proper operation.
