C 2500 Suburban 2WD V8-350 5.7L (1994)
Adjusting Ignition Switch
ADJUST
^
Ignition switch assembly (41).
A. Move switch slider to extreme left position.
B. Move switch slider one detent to right "OFF-LOCK" position.
2. Ignition switch assembly (41) and dimmer & ignition switch mounting stud (46).
TIGHTEN
^
Tighten stud (46) to 4.0 Nm (35 lb.in.).
3. Dimmer switch assembly (43) to rod (45).
4. Washer head screw (44) and hexagon nut (42).
^
Tighten finger tight.
Adjusting Dimmer Switch
ADJUST
^
Dimmer switch (43).
A. Place 3/32-inch drill bit in hole on switch to limit travel.
B. Position switch on column and push against dimmer switch rod (45) to remove all lash.
C. Remove drill bit.
TIGHTEN
^
Tighten screw (44) and nut (42) to 4.0 Nm (35 lb.in.).
5. Vehicle wire harness to ignition switch (41).
6. Negative (-) battery cable.
ADAPTER & BEARING ASSEMBLY
REMOVE OR DISCONNECT