C 2500 Truck 2WD L6-292 4.8L (1986)
Removing bearing retainer ring
7.
Using a suitable pliers, remove outer bearing retaining ring, Fig. 10.
8.
Using an old axle shaft or equivalent, drive on axle shaft spacer to remove outer bearing assembly from hub.
9.
Position axle shaft spacer and outer bearing into hub, ensuring larger side of bearing faces outer end of hub.
10.
Position outer bearing cup into hub with thin edge facing toward outer end of hub, then press cup into hub.
11.
Install retaining ring, then press cup into contact with ring.
12.
Drive inner bearing cup into hub, then install new oil seal.
13.
Reverse Steps 1 through 5 to complete installation, then adjust wheel bearings as outlined in ``Wheel Bearing, Adjust'' procedure.
