C 2500 Truck 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Tighten nut to 50 N.m (37 lbs. ft.).
Tighten bolt to 33 N.m (24 lbs. ft.).
5. Rear mounting nuts (6.5L diesel engine).
Tighten
Tighten nuts to 50 N.m (37 lbs. ft.).
6. Front brace (6.5L diesel engine).
Tighten
Tighten bolts to 40 N.m (30 lbs. ft.).
Tighten nut to 40 N.m (30 lbs. ft.).
7. Pulley.
^
Place pulley on the end of the pump shaft.
^
Install J 25033-B. Be sure the pilot bolt bottoms in the shaft by turning the nut to the top of the pilot bolt.
^
Hold the pilot bolt.
^
Turn the nut clockwise.
^
Install pulley flush ± 0.25 mm (0.010 in.) with the end of the power steering pump shaft.
NOTICE: Do not use arbor press or internal damage to the pump will result.
8. Belt.
9. Load the tensioner assembly.
10. Hoses.
^
Fill and bleed the system.
Inspect
^
Hoses for clearance.
