C 2500 Truck 2WD V8-5.7L VIN R (1997)
Air Bag: Service and Repair
Deployed Inflator Module
Install or Connect
Install or Connect
1. The inflatable restraint I/P module to the mounting bracket, using the two retaining clips to hold the inflatable restraint I/P module in position.
2. The fasteners to the inflatable restraint I/P module.
Tighten
^
The fasteners to 10 Nm (89 lb in).
3. The inflatable restraint I/P module pigtail harness to the I/P harness clips.
4. The new I/P carrier.
^
Enable the SIR system, refer to Air Bag(s) Arming and Disarming.
Tighten
^
The fasteners to 10 Nm (89 lb in).
Preliminary Precautions
After the inflator module has been deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of cornstarch
(used to lubricate the bag as it inflates) and by-products of the chemical reaction. Sodium hydroxide dust (similar to lye soap) is produced as a
by-product of the deployment reaction. The sodium hydroxide then quickly reacts with atmospheric moisture and is converted to sodium carbonate and
sodium bicarbonate (baking soda). Therefore, it is unlikely that sodium hydroxide will be present after deployment. As with many service procedures,
you should wear gloves and safety glasses.
Remove or Disconnect