C 2500 Truck 2WD V8-5.7L VIN R (1997)
Push Rod: Service and Repair
Push Rod Replacement - Removal
REMOVAL
1. Remove the valve rocker arm cover.
2. Remove the valve rocker arm nut. If only the pushrod is to be replaced, back the valve rocker arm nut off until the valve rocker arm can be swung
away from the pushrod. Then pull the pushrod out.
3. Remove the valve rocker arm with the ball.
NOTE: Store used components in order so they can be reassembled in the same location.
4. Remove the pushrod.
5. Inspect the valve rocker arms and balls at their mating surfaces. These surfaces should be smooth and free from scoring or other damage.
6. Inspect the valve rocker arm areas that contact the valve stems and the sockets that contact the pushrods. These areas should be smooth and free of
damage and wear.
7. Inspect the pushrods for bending. Roll the pushrod on a flat surface to determine if the pushrod is bent. Replace the pushrod if necessary.
8. Inspect the ends of the pushrods for scoring or roughness.