C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Install the camshaft sensor bolt and sensor.
^
Tighten the camshaft sensor bolt to 9 Nm (80 inch lbs.).
10. Connect the camshaft sensor electrical connector.
Important: The crankshaft position sensor spacers are machined with different timing positions. If the spacer requires replacement, replace with the
same part number.
11. Install the crankshaft position sensor spacer.
12. Install the crankshaft position sensor spacer bolts
^
Tighten the crankshaft position sensor spacer bolts to 10 Nm (89 ft. inch).
13. Install the crankshaft position sensor.
14. Install the crankshaft position sensor bolt.
^
Tighten the crankshaft position sensor bolt to 10 Nm (89 inch lbs.).
15. Install the water pump.
16. Install the crankshaft front oil seal.
17. Install the crankshaft balancer.
18. Install the thermostat housing crossover.
19. Install the oil fill tube.
20. Install the drive belt.
21. Install the upper fan shroud.
22. Install the right front fender wheelhouse panel.
23. Fill the engine coolant.
24. Connect the battery negative cable.
