C 2500 Truck 2WD V8-8.1L VIN G (2002)
Rear Fender: Service and Repair
Rear Fender Replacement (Step Side)
Rear Fender Replacement (Step Side)
Removal Procedure
1. Remove the front filler bolts.
2. Remove the step pad.
3. Remove the lower fender brace rod bolts.
4. Remove the fender step bolts.
5. Remove the fender molding push-pins.
6. Remove the tail lamp assembly. Refer to Tail/Turn Signal Lamp Replacement (Except Stepside) Tail/Turn Signal Lamp Replacement (Stepside)
.
7. Remove the fender to rear pillar retaining bolts through the tail lamp opening.
8. Remove the rear retaining screws.
9. Remove the top fender molding push-pin retainer.
10. Remove the top fender molding.
11. Use the following procedure in order to remove the fender from the vehicle:
1. Lift the fender up 90 degrees.
2. Slide the fender outward.
