C 2500 Truck 2WD V8-8.1L VIN G (2002)
4. Remove the nut and the bolt from the quarter shaft shield.
5. Remove the shield.
6. Remove the 2 brake caliper bracket mounting bolts.
7. Mark the relationship of the rotor to the hub.
Notice: Refer to Support the Brake Caliper While Flex Hose is Connected Notice in Service Precautions.
8. Remove the brake caliper and brake caliper mounting bracket as an assembly and support with heavy mechanic's wire or equivalent. DO NOT
disconnect the hydraulic brake flexible hose from the caliper.
9. Remove the rotor retaining push nuts from the wheel studs, if applicable.
10. It may be necessary to strike the end of the hub or the rotor with a deadblow hammer to separate the rotor from the hub.
11. Remove the rotor by slowly turning the rotor while pulling the rotor away from the axle.
Installation Procedure
Notice: Whenever the brake rotor has been separated from the wheel bearing flange, clean any rust or foreign material from the mating surface of the
rotor and flange with the J42450 hub cleaning kit. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
