C 2500 Truck 2WD V8-8.1L VIN G (2002)
^
Tighten the stub shaft housing bolts to 55.0 - 70.0 Nm (40.5 - 51.6 ft. lbs.).
680 Gear
Stub Shaft Housing Replacement (680 Gear)
Disassembly Procedure
Important: Replace the housing if the stub shaft housing, seal or bearing are damaged.
1. Remove the stub shaft housing bolts (4) from the stub shaft housing (3).
2. Remove the stub shaft housing (3) from the steering gear.
3. Remove the stub shaft housing O-rings (1) (2) from the steering gear.
Assembly Procedure
1. Grease the stub shaft seal with the special grease supplied with the new stub shaft housing.
2. Install the new stub shaft housing O-rings (1) (2).
3. Install the stub shaft housing (3) onto the steering gear.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the stub shaft housing bolts (4) into the stub shaft housing (34).
^
Tighten the bolts to 55.0 - 70.0 Nm (40.5 - 51.6 ft. lbs.).
Tie Rod Replacement - Inner (Quiet Valve)
Tie Rod Replacement - Inner (Quiet Valve)
^
Tools Required
-
J 34028 Inner Tie Rod Wrench
Disassembly Procedure
