C 2500 Truck 2WD V8-8.1L VIN G (2002)
6. Disconnect the internal wiring harness connectors (1) from solenoids A through F and from the pressure switch assembly.
Important: The solenoid retainers for E and D solenoid also retain tabs on the wiring harness U-channel. The solenoids will remain in position even
after the solenoid retainers are removed.
7. Remove the solenoid retainers (2) for solenoids E and D.
8. Remove the internal wiring harness from the transmission.
Installation Procedure
1. Align the tabs (8) on the new wiring harness U-channel with the solenoid retainer slots for solenoids E (3) and D (2) on the control valve assembly.
Install the solenoid retainers (14) for the E (3) and D (4) solenoids.
Important: The internal wiring harness connectors (7) and (9)-(13) should be in the correct position for installation because of their preassembled
position in the U-channel.
2. Attach the internal wiring harness connectors to solenoids A through F and to the pressure switch assembly.
