C 2500 Truck 2WD V8-8.1L VIN G (2002)
4. Position the input shaft bearing retainer.
5. Align the bearing retainer oil drain hole at the top dead center position.
6. Apply threadlock GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the input shaft bearing retainer bolts.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the input shaft bearing retainer bolts.
^
Tighten the input shaft bearing retainer bolts to 22 Nm (16 inch lbs.).
8. Install the clutch actuator cylinder and bolts.
^
Tighten the clutch actuator cylinder bolts to 8 Nm (71 inch lbs.).
9. Install the transmission.
10. Lower the vehicle.
Transmission Housing Oil Seal Replacement (Rear)
Transmission Housing Oil Seal Replacement (Rear)
^
Tools Required
-
J 8614-01 Pinion Flange Holder
-
J 6125-1P Slide Hammer
-
J 22834-A Rear Extension Housing Oil Seal Installer
-
J 23129 Universal Seal Remover
Removal Procedure
