C 2500 Yukon XL 2WD V8-6.0L VIN U (2001)
Output Shaft: Service and Repair
ZF S6-650 - Manual Transmission
Transmission Housing Oil Seal Replacement (Rear Oil Seal)
^
Tools Required
-
J 6125-1B Slide Hammer
-
J 44732 Output Shaft Oil Seal Installer
-
J 23129 Universal Seal Remover
-
J 8614-01 Pinion Flange Holder
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Using the J 8614-01 on the transmission yoke, remove the yoke flange nut. Discard the nut.
4. Remove the propeller shaft yoke.
5. Remove the rear oil seal from the rear case using the J 6125- 1B (1) and the J 23129 (2).