C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
2. Install the splash shield, for 25 series.
3. Install the hub and bearing assembly.
4. Install the tire and wheel assembly.
5. Remove the safety stands.
6. Lower the vehicle.
Rear
Disc Brake Backing Plate Replacement - Rear
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Relieve the tension from the park brake cables by loosening the nut at the equalizer.
5. Remove the rear park brake cable from the park brake actuator lever.
6. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
7. Remove the rotor.
8. Remove the axle shaft.
9. Remove the park brake shoe.
10. Remove the backing plate nuts.
11. Remove the backing plate from axle housing flange.
Installation Procedure
