C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
3. Install the water deflector.
4. Install the trim panel.
Door Inside Handle Replacement
Door Inside Handle Replacement
Tools Required
J 34940 Rivet Gun
Removal Procedure
1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the inside door handle assembly by completing the following steps:
*
Drill out the rivet head using a 5 mm (0.2 in) drill bit.
*
Slide forward the door handle.
4. Disconnect the control rods from the handle and the lock lever.
Installation Procedure
1. Connect the control rods to the handle and the lock lever.
2. Install the inside door handle by completing the following steps:
*
Insert the handle assembly into the slot.
*
Slide the assembly to the rear.
*
Using the J 34940 , install the handle rivet.
3. Install the water deflector.
4. Install the trim panel.
