C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
2. Install the bolts that mount the brake rotor to the hub, or the wheel.
Tighten the brake rotor bolts (5/8 in OD-5 bolt pattern) to 256 Nm (189 ft. lbs.).
Important: Ensure that the threads are clean and greaseless before applying the threadlocker.
3. Apply 272 Threadlocker GM P/N 12345493, or the equivalent, to the threads of each brake rotor bolt.
4. Install the brake rotor.
5. Inspect the brake rotor for runout after installation.
6. Clean both sides of the brake rotor with Brake Parts Cleaner GM P/N 12345754 or the equivalent.
7. Clean the grease cap or cover.
8. Coat the inside of the grease cap with new wheel grease. Do not fill the cap.
9. Install the brake caliper.
10. Install the tire and wheel.
11. Lower the vehicle.
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
Important: Check the level of the brake fluid in the master cylinder reservoir after pumping the brake pedal.
12. Pump the brake pedal several times in order to ensure the pedal is firm and the brake pads are adjusted.
13. Remove the blocks.
Rear
Brake Rotor Replacement - Rear
Removal Procedure
1. Block the wheels.
2. Apply the park brake.
3. Raise the vehicle. Support the vehicle with suitable stands. Refer to Vehicle Lifting.
