C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
10. Remove the inlet heater hose from the thermostat housing and position out of the way.
11. Remove the thermostat housing crossover from cylinder heads.
12. Remove the power steering pump from the engine lift bracket.
13. Remove the bolts from the engine lift bracket.
14. Remove the engine lift bracket from the engine block.
15. Clean the mating surfaces of the cylinder and crossover.
Installation Procedure
1. Install the engine lift bracket to the engine block.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine lift bracket bolts to the cylinder head.
Tighten the bolts to 50 Nm (37 ft. lbs.).
3. Install the power steering pump to the engine lift bracket.
4. Install the thermostat housing crossover to the cylinder heads.
