C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Compressor Clutch: Service and Repair
Compressor Clutch Plate and Hub Assembly Removal (HT6/HD6/HU6)
TOOLS REQUIRED
-
J 34992 Compressor Holding Fixture
-
J 33013-B Hub and Drive Plate Remover/Installer
1. Clamp the J 34992 in a vise.
2. Use thumb screws in order to attach the compressor to the holding fixture.
NOTE: Do not drive or pound on the clutch hub or shaft. Internal damage to the compressor may result. The forcing tip on the J 33013-B
remover/installer center screw must be flat or the end of the shaft/axial plate assembly will be damaged.
3. Ensure that the center screw forces the tip to thrust against the end of the shaft.
4. Thread the J 33013-B into the hub.
5. While holding the body of J 33013-B of the remover with a wrench, turn the center screw into the remover body in order to remove the clutch
plate and hub assembly (1).
6. Remove the shaft key. Retain the shaft key for reassembly.
For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID See: Application and
ID/RPO Codes
