C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
1. Install a drain pan under the vehicle.
2. Remove the brake booster inlet hose (1) from the brake booster (2).
3. Remove the brake booster inlet hose from the power steering pump.
4. Remove the brake booster inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the brake booster inlet hose (1) to the brake booster (2).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the brake booster inlet hose to the power steering pump.
-
Tighten the brake booster inlet hose fittings to 27 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system. Refer to Bleeding the Power Steering System.
Power Brake Booster Outlet Hose Replacement
-
Tools Required
-
J 43218 Clamp Pliers
Removal Procedure
Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
