C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Fuel: Service and Repair
Fuel System Cleaning
FUEL SYSTEM CLEANING
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Remove the negative battery cables.
2. Remove the fuel from the tank.
4. Remove the fuel sender.
5. Clean the fuel tank.
IMPORTANT: The fuel tank should be replaced if the tank is rusted internally.
6. Remove the fuel strainer or replace if necessary. Refer to Fuel Sender Assembly Replacement.
7. Remove the fuel lift pump.
8. Remove the fuel manager/filter.
9. Remove the fuel return line at the injection pump.
^
Use low air pressure to blow out the lines toward the rear of the vehicle.
^
Replace the pipes if they are rusted internally.
10. Remove the fuel filter from the fuel manager housing.
11. Wipe out the inside of the housing with a clean towel.
12. Remove the heater element from the housing.
13. Remove the water in fuel sensing element from the housing.
14. Clean the inside of the filter housing with GM brake parts cleaner or equivalent.
15. Dry the housing completely.
INSTALLATION PROCEDURE
1. Install the water-in-fuel sensing element using a new seal.
2. Install the heater element with a new O-ring seal.
3. Install the fuel filter into the fuel manager.
4. Install the fuel manager/filter.
5. Install the fuel sender.
6. Install the fuel tank.
7. Install the new fuel lift pump.
8. Install clean diesel fuel into the tank until 1/4 full.
9. Install the fuel tank cap.
10. Install the negative battery cables.
11. Remove the ECM 1 fuse from the underhood relay center.
IMPORTANT: Use a suitable container to catch the fuel.
12. Install a hose from the fuel injection pump inlet hose (hose to hose) at the fuel injection pump to a closed metal container with a capacity of at least
8 liters (2 gallons).
13. Crank the engine for 15 seconds with one minute cooling periods until the clean fuel is pumped out.
14. Reinstall the inlet hose to the injection pump.
15. Install the ECM 1 fuse in the underhood relay center.
16. Install a hose from the return line at the fuel injection pump to a closed metal container with a capacity of at least 8 liters (2 gallons).
17. Crank the engine for 15 seconds with one minute cooling periods until clean fuel appears at the return line.
IMPORTANT: Ensure the fuel return line is in the metal container and that the container does not overflow.
^
Start the engine and allow to idle for 5 minutes.
^
Remove the hose from the metal container.
18. Reinstall the fuel return line to the injection pump.
19. Check for leaks.
20. Clear any engine DTCs.
GASOLINE IN FUEL SYSTEM
Engine Will Run Or Start
1. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
2. Fill the fuel tank to 1A with diesel fuel.
3. Run the engine for 15 minutes.
