C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Stabilizer Bushing: Service and Repair
Removal Procedure
1. Set the parking brake.
2. Block the vehicle's rear wheels.
3. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Vehicle Lifting.
4. Loosen the lower nut at the stabilizer shaft.
5. Remove the following components connecting the stabilizer shaft to the front axle:
-
The nut
-
The washers
-
The insulators
6. Pivot the stabilizer shaft out of the way to allow access to the bracket.
7. Remove the following components from the front axle:
7.1.
The nuts
7.2.
The washers
7.3.
The insulator
8. Remove the bracket from the front axle.
Installation Procedure
1. Install the stabilizer shaft bracket to the front axle.
2. Install the following components to the front axle stabilizer bracket:
2.1.
The insulator
2.2.
The washers
2.3.
The nuts
Notice: Refer to Fastener Notice in Service Precautions.
-
Tighten the stabilizer shaft bracket nuts to 29 Nm (21 ft. lbs.).
3. Align the stabilizer shaft stud with the stabilizer bracket hole.
