C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Notice: Refer to Fastener Notice in Service Precautions.
6. Tighten the inner wheel bearing adjuster nut using the J2222-C.
Tighten
Tighten the inner wheel bearing adjuster nut to 68 Nm (50 lb ft) while rotating the wheel hub assembly.
7. Make sure the bearing cones are seated and are in contact with the spindle shoulder.
8. Loosen the inner wheel bearing adjuster nut and retighten the adjuster nut using the J2222-C.
Tighten
Tighten the inner wheel bearing adjuster nut to 47 Nm (35 lb ft) while rotating the wheel hub assembly.
9. Loosen the inner wheel bearing adjuster nut 135150 degrees by turning the nut counterclockwise using the J2222-C.
10. Install the new wheel bearing adjuster nut lock as follows:
10.1.
Bend the outer tab on the wheel bearing adjuster nut lock as shown.
10.2.
Install the wheel bearing adjuster nut lock onto the axle shaft aligning the inner tab with the slot on the axle shaft.
10.3.
If the outer tab on the wheel bearing adjuster nut lock does not engage one of the slots on the inner wheel bearing adjuster nut, remove the
wheel bearing adjuster nut lock and turn the outer wheel bearing adjuster nut counterclockwise using the J2222-C until the slot on the inner
wheel bearing adjuster nut is aligned with the outer tab on the wheel bearing adjuster nut lock.
10.4.
Re-install the wheel bearing adjuster nut lock.
11. Install the outer wheel bearing adjuster nut using the J2222-C.
Notice: Refer to Fastener Notice in Service Precautions.
12. Tighten the outer wheel bearing adjuster nut.
