C 3500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
5.
Back off adjusting nut one flat. If hole in spindle lines up with slot in nut, insert cotter pin. If hole and slot do not line up back nut off until hole
and slot align. Do not back the nut off more than one additional flat.
3500 Except HD
FRONT WHEEL BEARINGS ADJUSTMENT
Fig. 1 Exploded View Of Hub, Knuckle & Bearing Components. 2WD Models
1.
Raise and support vehicle.
2.
Remove wheel cover, if equipped.
3.
Remove cap from hub/disc assembly.
4.
Remove cotter pin.
5.
Tighten nut (12), Fig. 1, to 12 ft. lbs., while turning wheel forward by hand. This will seat the bearing.
6.
Loosen nut (12) to a just loose position, then back nut off until hole in the spindle aligns with a slot in the nut. Do not back the nut off more than
1/2 flat.
