C 3500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
2.
Locate accelerator cable between accelerator lever assembly and bulkhead under dash (Figure 1).
3.
Measure minimum clearance between accelerator cable and dash mat.
4.
If clearance of at least 12 mm (0.5 in.) exists between cable and dash insulator mat through entire range of pedal travel, proceed to step 7.
5.
Inspect area under mat around location to insure no wiring was routed under this section.
6.
Using a carpet knife or similar tool, carefully cut away a sufficient section of the dash mat to provide at least 12 mm (0.5 in.) clearance between
pad and accelerator cable through entire range of motion.
7.
Install Campaign Identification Label.
Campaign ID Label & Claim Information
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provide a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner. When installing the new Campaign Identification Label, be sure to install the clear protective covering. Additional
Campaign Identification Labels can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m. to 4:30 p.m. EST).
Ask for Item Number S-1015 when ordering.
