C 3500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
Pitman Arm: Service and Repair
2 Wheel Drive
IMPORTANT: Use the proper tool to separate all ball joints.
REMOVE OR DISCONNECT
TOOLS REQUIRED:
^
J 24319-01 Steering Linkage Puller.
^
J 29107 Pitman Arm Puller.
^
J 6632-01 Pitman Arm Remover.
^ Raise the vehicle. Support the vehicle with jack stands.
1. Relay rod nut (11) from the pitman arm ball stud (5). Do not reuse the nut.
2. Relay rod (14) from the pitman arm ball stud (5) using J 24319-01.
3. Pitman arm nut and washer.
^
Mark the pitman arm and the pitman shaft. This will permit proper alignment at assembly.
NOTICE: Do not hammer on pitman arm, pitman shaft, or puller. Damage to pitman arm or steering gear may result.
4. Pitman arm. Use J 6632-01 or J 29107.
INSPECT
^
Ball stud threads for damage.
^
Ball stud seals for excessive wear.
CLEAN
^
Threads on the ball stud.
