C 3500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
Pitman Arm: Service and Repair
I-Beam Front Axle (C3HD Models)
IMPORTANT: Use the proper tool to separate all ball joints.
Steering Linkage I-Beam Front Axle (C3HD Models)
REMOVE OR DISCONNECT
TOOLS REQUIRED:
^
J 24319-01 Steering Linkage Puller.
^
J 29107 Pitman Arm Puller.
^
J 6632-01 Pitman Arm Remover.
^ Raise the vehicle. Support the vehicle with jack stands.
1. Drag link (31) from pitman arm ball stud.
2. Pitman arm nut (38) from steering gear shaft. (Do not reuse nut.)
^
Mark the pitman arm and the pitman shaft. This will permit proper alignment at assembly.
3. Pitman arm using J 6632-01 or J 29107.
INSPECT
^
Ball stud threads for damage.
^
Ball stud seals for excessive wear.
CLEAN
^
Threads on the ball stud.
