C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
Wheel Bearing: Service and Repair
All C Trucks Except C 3500 HD
FRONT WHEEL BEARING/HUB
REMOVAL PROCEDURE
1. Remove the brake caliper.
Notice: Support the caliper with a piece of wire to prevent damage to the brake line.
2. Remove the cap from the hub/rotor.
3. Remove the cotter pin, the nut, and the washer.
4. Remove the hub/rotor from the spindle.
Important: Do not damage the outer bearing and the spindle threads.
5. Remove the outer bearing.
6. Remove the seal. Pry the seal out and discard the seal.
7. Remove the inner bearing.
8. Clean all of the parts in a solvent, then air dry. Do not spin the bearings with compressed air.
Notice: Do not spin the wheel bearings with compressed air to dry them-the wheel bearings may be damaged.
9. Inspect the hub/rotor.
10. Inspect the bearings and the races for wear or damage. Replace the parts as necessary.
INSTALLATION PROCEDURE
1. Install the inner bearing to the hub/rotor.
Important:
^
Make sure all of the parts are clean and free of grease.
