C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
Power Steering Fluid Cooler: Service and Repair
Fin Type Power Steering Cooler
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the washer solvent container.
4. Remove the power steering cooler line (4) from the power steering gear.
Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
5. Remove the power steering cooler line (3) from the power steering pump.
6. Remove the power steering hose clip from the radiator support.
7. Remove the front center filler panel.
8. Remove the power steering cooler bracket screws.
9. Remove the power steering cooler from the vehicle.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
INSTALLATION PROCEDURE
1. Route the cooler in the same position the cooler occupied prior to removal.
2. Install the power steering cooler bracket screws.
-
Tighten the power steering cooler bracket screws to 8 Nm (6 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
