C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
5. Install the inner wheel bearing into the hub/rotor. Put an additional quantity of grease outboard of this bearing.
6. Install the new seal.
6.1. Using a seal installer or a block, install the seal in order to ensure that the seal is flush with the hub/rotor flange.
6.2. Lubricate the seal lip with a thin layer of grease.
7. Install the hub/rotor. Do not damage the steering knuckle spindle threads.
8. Install the outer wheel bearing. Slide the bearing over the spindle until the wheel bearing fully seats against the hub/rotor outer race.
9. Install the washer, the nut, and the cotter pin. Do not place the cotter pin through the hole in the spindle until the wheel bearings are adjusted.
^
Tighten the nut to 16 Nm (12 ft. lbs.), while turning the hub/rotor assembly by hand.
9.1. Apply an additional amount of grease outboard of the wheel bearing.
9.2. Adjust the wheel bearings.
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the cotter pin.
11. Install the retainer/cap in place.
12. Install the brake caliper.
13. Install the tire and wheel assembly.
14. Lower the vehicle.
