C 3500 Truck 2WD V8-6.0L VIN U (2001)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
Camshaft Position Sensor (CMP)
1. Disconnect the electrical connector from the camshaft position (CMP) sensor.
IMPORTANT: Clean the area around the CMP sensor before removal in order to prevent debris from entering the engine.
2. Remove the CMP sensor retaining bolt.
3. Remove the CMP sensor.
INSTALLATION PROCEDURE
Camshaft Position Sensor (CMP)
1. Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the CMP sensor retaining bolt.
Tighten
Tighten the bolt to 29 N.m (21 lb ft).
3. Connect the CMP sensor electrical connector.
