C 3500 Truck 2WD V8-6.0L VIN U (2001)
42. Disconnect the RF side impact module connector (1) from the vehicle wiring harness (2) located under the RF seat.
43. Out the RF side impact module harness connector out of the vehicle leaving at least 16 cm (6 in) of wire at the connector.
44. Strip 13 mm (0.5 in) of insulation from each of the RF side impact module connector wire leads.
45. Gut 2 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the deployment harness.
46. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
47. Twist together 1 end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the side air bag module.
