C 3500 Truck 2WD V8-6.0L VIN U (2001)
66. Move the power source, 12 V minimum/2 A minimum (i.e., a vehicle battery) near the shorted ends of the driver side deployment harnesses.
67. Separate the 2 ends of the steering wheel module deployment harness wires.
68. Connect the steering wheel module deployment harness wires to the power source in order to deploy the steering wheel module.
69. Disconnect the steering wheel module deployment harness wires from the power source.
70. Separate the 2 ends of the LF side impact module deployment harness wires
71. Connect the LF side impact module deployment harness wires to the power source in order to deploy the side impact module.
72. Disconnect the LF side impact module deployment harness wires from the power source.
73. Twist together 1 end of each wire of the steering wheel module on the driver side deployment harness in order to short the wires.
74. Twist together 1 end of each wire of the LF side impact module on the driver side deployment harness in order to short the wires.
75. Remove the drop cloth from the vehicle.
76. Disconnect all harnesses from the vehicle.
77. Discard the harnesses.
78. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
79. If 1 or all of the inflator modules did not deploy, perform the following steps to remove the undeployed module(s) from the vehicle:
^
Inflatable Restraint Steering Wheel Module Replacement
^
Inflatable Restraint Instrument Panel Module Replacement
^
Inflatable Restraint Side Impact Module Replacement - Front
80. Contact the Technical Assistance Group for further assistance.
