C 3500 Truck 2WD V8-6.0L VIN U (2001)
1. Inspect the splines of the transfer case output shaft for a sufficient coating of grease. If the output shaft does not have a sufficient coating of grease,
lubricate the shaft with grease (GM P/N 12345879 or equivalent).
2. Install the new clamp into the groove of the propeller shaft boot.
3. Install the propeller shaft splines into the transfer case output shaft.
4. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the yoke retainers (7) and the bolts (6).
^
Tighten the yoke retainer bolts to 25 Nm (19 ft. lbs.).
6. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
7. Using the J 43218, crimp the clamp until the dimensions shown are obtained.
8. Install the transfer case shield (if equipped).
9. Lower the vehicle.
