C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Windshield Moulding / Trim: Service and Repair
Windshield Upper Reveal Molding Replacement
Windshield Upper Reveal Molding Replacement
Tools Required
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Plastic Paddle
Removal Procedure
1. Remove both right and left sides of the reveal molding. Refer to Windshield Side Reveal Molding Replacement (See: Windshield Side Reveal
Molding Replacement).
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
Important: The windshield reveal molding fills the cavities between the body and windshield. If the reveal molding is stretched or
damaged it and cannot be reused it must be replaced.
2. Remove the upper windshield reveal molding.
1. Use a flat-bladed tool in order to carefully pry the end of the upper reveal molding out about 76 mm (3 in).
2. Grasp the corner of the windshield reveal molding by hand or use a suitable tool to slowly pull the reveal molding away from the windshield.
3. If the windshield reveal molding will not release, use a utility knife to aid in the releasing of the molding.
Installation Procedure
1. Clean the top edge of the windshield surface with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint - free cloth.
2. The new reveal molding should be fitted to the windshield prior to installation.
Caution: Refer to Window Retention Caution in Cautions and Notices.
3. Verify all primers and urethane adhesive are within expiration dates.
Important: Use care when applying the prep (clear #1) to the windshield. This primer dries almost instantly, and may stain the viewing
area of the windshield if not applied evenly.
