C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Install the lumbar actuator (5).
6. Install the seat switch bezel. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement (See: Power Seat Switch/Service and Repair).
7. Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.
8. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness (if equipped with power lumbar).
9. Connect the electrical connectors.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) in Cautions and Notices.
10. Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten the nuts to 21 Nm (15 lb ft).
