C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Important: Do not reuse the EBCM mounting bolts. Always install new bolts.
10. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
11. Clean the EBCM to BPMV mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the EBCM (2) onto BPMV (1).
Important: Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.
2. Install the four EBCM bolts.
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X pattern.
3. Connect the 2 way ABS pump motor connector to the EBCM.
4. Install the BPMV (1)to BPMV bracket (3).
5. Install the BPMV to bracket retaining bolts (4).
Tighten the bolts to 9 Nm (7 ft. lbs.).
6. Install the EHCU (1, 2) to the vehicle frame (5).
Tighten the three EHCU bracket bolts (4) to 25 Nm (18 ft. lbs.).
7. Connect the two electrical harness connectors to the EBCM (1).
Important: The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct place
for proper reassembly.
8. Install the 5 brake pipes to the BPMV (6).
