C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Adjust the park brake shoe.
6. Install the rotor.
7. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
8. Install the rear park brake cable to the park brake actuator lever.
9. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
10. Install the tire and wheel assembly.
11. Remove the safety stands.
12. Lower vehicle.
13. Adjust park brake cable.
Rear (W/NYS)
Disc Brake Backing Plate Replacement Rear (W/NYS)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Relieve the tension from the park brake cable by pulling down on the intermediate cable then release the cable from the equalizer bar.
