C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Installation Procedure
1. Install the anti-rattle clips to the brake caliper mounting bracket.
2. Install the brake pads to the brake caliper mounting bracket.
3. Install the brake caliper to the brake caliper mounting bracket.
4. Install the brake caliper mounting bolts to the brake caliper mounting bracket. Do not tighten.
5. Install the brake caliper and brake caliper mounting bracket (1) as an assembly.
6. Perform the following procedure before installing the brake caliper mounting bracket bolts.
^
Remove all traces of the original adhesive patch .
^
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
^
Apply Threadlock GM P/N 12345493 or Canadian P/N 10953488 to the threads of the bolt.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the brake caliper mounting bracket bolts (2).
Tighten the brake caliper mounting bracket bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper mounting bolts (2).
Tighten the brake caliper mounting bolts to 108 Nm (80 ft. lbs.).
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds, then repeat steps 11-12 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Rear (W/NYS)
Brake Caliper Bracket Replacement Rear (W/NYS)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
